Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 Charging System Indicator Circuit Troubleshooting

1. Turn the ignition switch ON (II). Does the charging system indicator come on? YES-Go to step 2. NO-Go to step 14. 2. Start the engine. Hold the engine speed at 2,000 rpm for 1 minute. Does the charging system indicator go off? YES-Charging system indicator circuit is OK. Go to the alternator

 XM radio display is blank and no station information is displayed

1. Disconnect audio disc changer 13P connector. 2. Turn the ignition switch to ACC (I). 3. Operate the XM radio, and check the display. Is XM information displayed? YES-Replace the audio disc changer. NO-Go to step 4. 4. Check the No. 34 (7.5 A) fuse in the under-dash fuse/relay box and the No.

© 2016-2025 Copyright www.hcrv.net