Honda CR-V: Exterior Lights
Honda CR-V (2006–2011) Service Manual / Body Electrical / Exterior Lights
Component Location Index
- DAYTIME RUNNING LIGHTS CIRCUIT
- HEADLIGHTS
- FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS
- HIGH MOUNT BRAKE LIGHT
- LICENSE PLATE LIGHT
- TAILLIGHT and BRAKE LIGHT
- REAR TURN SIGNAL LIGHT
- BACK-UP LIGHT
- LIGHTS-ON INDICATOR
- HIGH BEAM INDICATOR
- DRL INDICATOR
- COMBINATION LIGHT SWITCH
- BRAKE PEDAL POSITION SWITCH
READ NEXT:
System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and t
DTC Troubleshooting
DTC B1078: Daytime Running Lights Signal
Error (Canada)
DTC B1079: Daytime Running Lights Signal
Error (USA)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN
MICU Input Test
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
T
SEE MORE:
Lower Ball Joint Replacement
Special Tools Required
Ball joint remover, 32 mm 07MAC-SL0A 102
Ball joint thread protector, 14 mm 071AF-S3VA000
1. Remove the front wheel.
2. Remove the flange bolt and flange nuts from the
lower arm (A).
NOTE: During installation, install a new flange bolt
and new flange nuts. After lightly
Power Flow
P Position
Hydraulic pressure is not applied to the clutch. Power is not transmitted to
the countershaft. The countershaft is locked
by the park pawl, interlocking the park gear.
N Position
Engine power transmitted from the torque converter drives the mainshaft idler
gear, the idler shaft idler ge
© 2016-2025 Copyright www.hcrv.net
