Honda CR-V: Keyless/Power Door Locks/Security System
Honda CR-V (2006–2011) Service Manual / Body Electrical / Keyless/Power Door Locks/Security
System
Component Location Index
- NAVIGATION UNIT or AUDIO UNIT
- IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
- MICU (Built into the under-dash fuse/relay box)
- HEADLIGHTS
- HORN
- HOOD SWITCH
- SECURITY INDICATOR
- UNLOCK BUTTON
- IGNITION KEY
- PANIC BUTTON
- LOCK BUTTON
- TRANSMITTER
- IGNITION KEY SWITCH
- DRIVER'S DOOR KEY CYLINDER
- DRIVER'S DOOR LOCK SWITCH (Built into the power window master switch)
- DRIVER'S DOOR LOCK ACTUATOR/KNOB SWITCH/ KEY CYLINDER SWITCH
- DRIVER'S DOOR SWITCH
- LEFT REAR DOOR LOCK ACTUATOR/KNOB SWITCH
- LEFT REAR DOOR SWITCH
- TAILGATE RELEASE ACTUATOR
- TAILGATE OUTER HANDLE SWITCH
- TAILGATE LATCH SWITCH
- FRONT PASSENGER'S DOOR LOCK SWITCH (Built into the front passenger's power window switch)
- FRONT PASSENGER'S DOOR LOCK ACTUATOR/KNOB SWITCH
- FRONT PASSENGER'S DOOR SWITCH
- RIGHT REAR DOOR LOCK ACTUAROR/KNOB SWITCH
- RIGHT REAR DOOR SWITCH
READ NEXT:
System Description
Security Alarm System
NOTE: This applies to EX and EX-L models.
The security alarm system is armed automatically after the doors, hood, and
tailgate are closed and locked. For the
system to arm, the
DTC Troubleshooting
DTC B1026: Front Passenger's Door Lock
Switch Signal Error (LOCK/UNLOCK)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System Diagnosis Test Mode A.
1. Cl
Symptom Troubleshooting
Power Door Locks/Keyless
1. Check for B-CAN DTCs. If any B-CAN DTCs are indicated, troubleshoot and
resolve them first.
2. If the door lock system and the keyless operation. does not work, troublesh
SEE MORE:
Ignition Switch
The ignition switch has four
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
LOCK (0) - You can insert or
remove the key only in this position.
To turn the key, the shift lever must
be in Park, and you must push the
key in slightly.
If the front wheels are turned, the
Cylinder Head Installation
1. Install a new coolant separator in the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and block surface.
3. Install the new cylinder head gasket (A) and dowel
pins (B) on the engine block. Always use a new
cylinder head gasket.
Set the crankshaft to top dead cen
© 2016-2026 Copyright www.hcrv.net
