Honda CR-V: Wipers/Washers
Honda CR-V (2006–2011) Service Manual / Body Electrical / Wipers/Washers
Component Location Index
- WINDSHIELD WIPER BLADES
- WIPER/WASHER SWITCH
- WINDSHIELD WIPER ARMS and LINK
- WINDSHIELD WIPER MOTOR
- UNDER-DASH FUSE/RELAY BOX
- UNDER-HOOD FUSE/RELAY BOX
- INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU)
- REAR WIPER BLADE
- REAR WIPER ARM
- REAR WINDOW WIPER MOTOR
- WINDSHIELD WASHER NOZZLES
- WASHER RESERVOIR
- WASHER MOTOR
- WASHER FLUID LEVEL SWITCH (Canada models)
- WASHER TUBES
- REAR WINDOW WASHER NOZZLE
- WASHER TUBE
Circuit Diagram - Windshield
Circuit Diagram - Rear Window
READ NEXT:
DTC Troubleshooting
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with th
MICU Input Test
1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and
check the No.8
(10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay
box.
2. Disconnect under-dash
Wiper/Washer Switch Test/Replacement
1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 8P
connector (A) from the wiper/washer switch (B).
3. Remove the two screws, then slide out the wiper/
washer switch.
SEE MORE:
Knuckle/Hub/Wheel Bearing Replacement
Exploded View
Special Tools Required
Hub dis/assembly tool 07GAF-SD40100
Ball joint remover, 32 mm 07MAC-SL0A102
Ball joint remover, 28 mm 07MAC-SL0A202
Ball joint thread protector, 14 mm 071AF-S3VA000
Attachment, 72 x 75 mm 077 46-0010600
Driver 077 49-0010000
Attachment, 96 mm 07948-SB001
Ignition Switch
The ignition switch has four
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
LOCK (0) - You can insert or
remove the key only in this position.
To turn the key, the shift lever must
be in Park, and you must push the
key in slightly.
If the front wheels are turned, the
© 2016-2025 Copyright www.hcrv.net
