Honda CR-V: Steering Gearbox
Honda CR-V (2006–2011) Service Manual / Steering / Steering Gearbox
READ NEXT:
Steering Gearbox Removal
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL0A202
Note these items during removal:
Using solvent and a brush, wash any oil and dirt off
the valve body unit, it's lines, and the end of
Steering Gearbox Overhaul
Exploded View
Special Tools Required
Cylinder end seal remover attachment
070AF-S7S0100
Valve seal ring sizing tool 07NAG-SR3090A
Sleeve seal ring guide 07YAG-S2X0100
Sleeve seal ring sizing t
Steering Gearbox Installation
NOTE: The illustrations show 2WD.
1. Before installing the steering gearbox, make sure
that no power steering fluid is on the mating
surface of the steering gearbox and the front
subframe. To prevent
SEE MORE:
EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator hose (A), heater hose
(B), and water bypass hose (C).
5. Remove the air cleaner housing brackets.
6
Replacing Rear Bulbs
1. Open the tailgate. Place a cloth on
the edge of the cover to prevent
scratches. Remove the covers by
carefully prying on the edge with a
small flat-tip screwdriver.
2. Use a Phillips-head screwdriver to
remove the taillight assembly
mounting screw under each cover.
3. Pull the t
© 2016-2025 Copyright www.hcrv.net
