Honda CR-V: Disc Player Error Messages (LX model)

Honda CR-V (2006–2011) Owner's Manual / Features / Disc Player Error Messages (LX model)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer.

The chart on the right explains the error messages you may see in the display while playing a disc.

If you see an error message in the display while playing a disc, press the eject button. After ejecting the disc, check it for damage or deformation. If there is no damage, insert the disc again.

For additional information on damaged discs.

The audio systemwill try to play the disc. If there is still a problem, the error message will reappear. Press the eject button, and pull out the disc.

Insert a different disc. If the new disc plays, there is a problem with the first disc. If the error message cycle repeats and you cannot clear it, take your vehicle to a dealer.

Error Message Cause Solution
CD FORMAT Track/File format not supported Current track will be skipped. The next supported track or file plays automatically.
BAD DISC CHECK MANUAL PUSH EJECT Mechanical Error Press the eject button and pull out the disc.

Check the disc for serious damage, signs of deformation, excessive scratches, and/or dirt. Insert the disc again. If the code does not disappear, or the disc cannot be removed, consult your dealer. Do not try to force the disc out of the player.

BAD DISC CHECK MANUAL Servo Error

The ejected disc will not be reloaded automatically.

READ NEXT:

 Playing the FM/AM Radio (EX and EX-L models without navigation system)

Playing the FM/AM Radio (EX and EX-L models without navigation system)

 To Play the FM/AM Radio

The ignition switch must be in the ACCESSORY (I) or ON (II) position. Turn the system on by pushing the FM or AM button. Adjust the volume by turning the VOL/SELECT knob. The band and frequenc

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the SEEK button to tune to a desired frequency.

SEE MORE:

 Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the upper torque rod. 3. Remove the ground cable (A), then remove the side engine mount bracket (B). 4. Install the side engine mount bracket, then loosely tighten the new bolt and nut (C), and loosely tighten the bolt

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doin

© 2016-2021 Copyright www.hcrv.net