Honda CR-V: Steering Gearbox
Honda CR-V (2006–2011) Service Manual / Steering / Steering Gearbox
READ NEXT:
Steering Gearbox Removal
Special Tools Required
Ball joint remover, 28 mm 07MAC-SL0A202
Note these items during removal:
Using solvent and a brush, wash any oil and dirt off
the valve body unit, it's lines, and the end of
Steering Gearbox Overhaul
Exploded View
Special Tools Required
Cylinder end seal remover attachment
070AF-S7S0100
Valve seal ring sizing tool 07NAG-SR3090A
Sleeve seal ring guide 07YAG-S2X0100
Sleeve seal ring sizing t
Steering Gearbox Installation
NOTE: The illustrations show 2WD.
1. Before installing the steering gearbox, make sure
that no power steering fluid is on the mating
surface of the steering gearbox and the front
subframe. To prevent
SEE MORE:
Replacing a Parking Light/Front Side Marker Light Bulb
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. P
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-Position Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Clear the DTC with the HDS.
2. Start the
© 2016-2025 Copyright www.hcrv.net
