Honda CR-V: Rear Suspension

READ NEXT:

 Knuckle/Hub Bearing Unit Replacement

Exploded View Hub Bearing Unit Replacement 1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the wheel nuts (A) and the rear wheel. 3. Remove t

 Upper Arm Replacement

1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Place a floor jack under the trailing arm, and support the suspension. 4.

 Damper/Spring

Damper/Spring Removal and Installation Removal 1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Remove the lid (A) on the

SEE MORE:

 Fuel Pump Circuit Troubleshooting

If you suspect a problem with the fuel pump, check that the fuel pump actually runs; when it is on, you will hear some noise if you listen to the fuel fill port with the fuel f ill cap removed. The fuel pump should run for 2 seconds when the ignition switch is first turned on. If the fuel pump does

 Moonroof

If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the ignition switch to the ON (II) position to operate the moonroof. To tilt up the moonroof, push

© 2016-2026 Copyright www.hcrv.net