Honda CR-V: Wipers/Washers
Honda CR-V (2006–2011) Service Manual / Body Electrical / Wipers/Washers
Component Location Index
- WINDSHIELD WIPER BLADES
- WIPER/WASHER SWITCH
- WINDSHIELD WIPER ARMS and LINK
- WINDSHIELD WIPER MOTOR
- UNDER-DASH FUSE/RELAY BOX
- UNDER-HOOD FUSE/RELAY BOX
- INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU)
- REAR WIPER BLADE
- REAR WIPER ARM
- REAR WINDOW WIPER MOTOR
- WINDSHIELD WASHER NOZZLES
- WASHER RESERVOIR
- WASHER MOTOR
- WASHER FLUID LEVEL SWITCH (Canada models)
- WASHER TUBES
- REAR WINDOW WASHER NOZZLE
- WASHER TUBE
Circuit Diagram - Windshield
Circuit Diagram - Rear Window
READ NEXT:
DTC Troubleshooting
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with th
MICU Input Test
1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and
check the No.8
(10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay
box.
2. Disconnect under-dash
Wiper/Washer Switch Test/Replacement
1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 8P
connector (A) from the wiper/washer switch (B).
3. Remove the two screws, then slide out the wiper/
washer switch.
SEE MORE:
EVAP Canister Replacement
1. Lift the vehicle, and support it with jackstands.
2. Remove the cover (A).
3. Remove the EVAP canister baffle cover (A).
4. Disconnect the hoses (A) and the fuel subharness
6P connector (B).
5. Remove the bolts (C) and the EVAP canister bracket
(D).
6. Remove the EVAP canister (A) from the E
Pressure Test
Special Tools Required
A/T clutch pressure gauge set
07406-0020400 or 07406-0020401
A/T pressure hose, 2,210 mm 07MAJ-PY4011A
A/T pressure hose adapter 07MAJ-PY40120
1. Make sure the transmission fluid is filled to the proper level.
2. 4WD model: Raise the vehicle on a lift, make sure it
is s
© 2016-2025 Copyright www.hcrv.net
