Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 Engine Lubrication

Special Tools Oil Filter Wrench Component Location Index OIL PAN WASHER DRAIN BOLT OIL PUMP OIL PUMP CHAIN GUIDE OIL PUMP CHAIN TENSIONER OIL CONTROL ORIFICE OIL FILTER OIL FILTER FEED PIPE OIL FILTER BASE ENGINE OIL GALLERY CAP OIL PRESSURE SWITCH Sym

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnect the side airbag harness 2P connector (A). 3. Remove the seat assembly and seat-back cover. 4. Re

© 2016-2025 Copyright www.hcrv.net