Honda CR-V: Wipers/Washers

Component Location Index

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Circuit Diagram - Windshield

Honda CR-V. Wipers/Washers

Circuit Diagram - Rear Window

Honda CR-V. Wipers/Washers

READ NEXT:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with th

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

SEE MORE:

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the DATA LIST with the HDS. Is about 176 ºF (80 ºC) or more, or 0.78 V or less indicated? YES-Go to s

 Steering Wheel

Steering Wheel Removal SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. 1. Make sure you have the anti-theft code for the audio and the navigation system (if equipped), then write down the XM audio preset

© 2016-2025 Copyright www.hcrv.net