Honda CR-V: Engine Lubrication

Special Tools

Honda CR-V. Engine Lubrication

  1. Oil Filter Wrench

Component Location Index

Honda CR-V. Engine Lubrication

Symptom Troubleshooting Index

Honda CR-V. Engine Lubrication

Low Oil Pressure Indicator Circuit Diagram

Honda CR-V. Engine Lubrication

READ NEXT:

 Low Oil Pressure Indicator Circuit Troubleshooting (Open)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2). 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the powertrain

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain ten

 Intake Manifold and Exhaust System

Intake Manifold Removal and Installation Exploded View Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disc

SEE MORE:

 DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine, and wait 1 minute. 4. Check for Temporary DTCs or DTCs with the HDS. Is DT

 Steering Gearbox Removal

Special Tools Required Ball joint remover, 28 mm 07MAC-SL0A202 Note these items during removal: Using solvent and a brush, wash any oil and dirt off the valve body unit, it's lines, and the end of the steering gearbox. Blow dry with compressed air. Be sure to remove the steering wheel before d

© 2016-2025 Copyright www.hcrv.net