Honda CR-V: Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 Glove Box Removal/Installation

NOTE: Take care not to scratch the dashboard and related parts. 1. Open the glove box (A), and detach the hook (B) of the glove box damper. While holding the glove box, release the glove box stop (C) on each side from the dashboard by pushing them in. 2. Close the glove box (A), then remove the bo

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on either No.1 or No.2 propeller shaft (B). 3. Start the engine, and let it run until it warms up (the ra

© 2016-2025 Copyright www.hcrv.net