Honda CR-V manuals

Honda CR-V: Fuel and Emissions Systems

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems

Special Tools

Honda CR-V. Fuel and Emissions Systems

Honda CR-V. Fuel and Emissions Systems

  1. Fuel Sender Wrench

  2. Fuel Pressure Gauge Attachment Set

  3. Vacuum/Pressure Gauge, 0-4 in.Hg

  4. Pressure Gauge Adapter

  5. Oil Pressure Hose

  6. A/T Pressure Hose

  7. A/T Low Pressure Gauge W/Pane

  8. A/T Pressure Hose, 2,210 mm

  9. A/T Pressure Hose, Adapter

  10. Fuel Pressure Gauge

READ NEXT:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

 System Description

Electronic Control System The functions of the fuel and emission control systems are managed by the powertrain control module (PCM). Self-diagnosis The PCM detects a failure of a signal from a sensor

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehi

SEE MORE:

 Upper/Lower Front Grille Replacement

Upper Front Grille Replacement NOTE: Take care not to scratch the bumper and grille. 1. Remove the front bumper. 2. Remove the clips from the back of the front grille and release the hooks (A), then release the hooks (B) and remove the upper front grille (C) from the lower front grille (D). 3. Re

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

© 2016-2025 Copyright www.hcrv.net