Honda CR-V: Engine Lubrication
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Lubrication
Special Tools
-
Oil Filter Wrench
Component Location Index
-
OIL PAN
-
WASHER
-
DRAIN BOLT
-
OIL PUMP
-
OIL PUMP CHAIN GUIDE
-
OIL PUMP CHAIN TENSIONER
-
OIL CONTROL ORIFICE
-
OIL FILTER
-
OIL FILTER FEED PIPE
-
OIL FILTER BASE
-
ENGINE OIL GALLERY CAP
-
OIL PRESSURE SWITCH
Symptom Troubleshooting Index
Low Oil Pressure Indicator Circuit Diagram
READ NEXT:
Low Oil Pressure Indicator Circuit
Troubleshooting (Open)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle
and the powertrain
Oil Pump Overhaul
Exploded View
Oil Pump Removal
1. Turn the crankshaft pulley so its top dead center
(TDC) mark (A) lines up with the pointer (B).
2. Remove the oil pan.
3. Remove and discard the oil pump chain ten
Intake Manifold and Exhaust System
Intake Manifold Removal and Installation
Exploded View
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disc
SEE MORE:
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the INSPECTION MENU with
the HDS.
Is the RELAY circuit OK? YES-Intermittent failure, the system is OK a
Consoles
Center Console Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing r
© 2016-2026 Copyright www.hcrv.net
