Honda CR-V: Interior Trim
Honda CR-V (2006–2011) Service Manual / Body / Interior Trim
Component Location Index
- TAILGATE SIDE TRIM
- Removal/Installation
- TAILGATE UPPER TRIM
- Removal/Installation
- QUARTER PILLAR GLASS TRIM
- Removal/Installation
- REAR DOOR OPENING SEAL
- Removal/Installation
- B-PILLAR UPPER TRIM
- Removal/Installation
- FRONT DOOR OPENING SEAL
- Removal/Installation
- SUNVISOR
- Removal/installation
- A-PILLAR TRIM
- Removal/Installation
- GRAB HANDLE
- Removal/Installation
- HEADLINER
- Removal/Installation
- FRONT SIDE OUTER TRIM
- Removal/Installation
- FRONT DOOR SILL TRIM
- Removal/Installation
- CARPET
- Replacement
- REAR SIDE OUTER TRIM
- Removal/Installation
- B-PILLAR LOWER TRIM
- Removal/Installation
- REAR DOOR SILL TRIM
- Removal/Installation
- DUAL DECK CARGO SHELF
- Removal/ Installation
- CARGO AREA FLOOR
- Removal/Installation
- TAILGATE LOWER TRIM PANEL
- Removal/Installation
- CARGO AREA SIDE TRIM PANEL
- Removal/Installation
READ NEXT:
Trim Removal/Installation
Trim Removal/Installation-Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are loc
Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Use the appropr
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before
doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Use the a
SEE MORE:
Idle Control System
Component Location Index
POWER STEERING PRESSURE (PSP) SWITCH
Signal Circuit Troubleshooting
A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
Signal Circuit Troubleshooting
POWERTRAIN CONTROL
MODULE (PCM)
General Troubleshooting Information
Replacement
A/C
Front Bumper
Front Bumper Removal/Installation
NOTE:
Have an assistant help you when removing and
installing the front bumper.
Take care not to scratch the front bumper and body.
Put on gloves to protect your hands.
1. Remove the front bulkhead cover.
2. Remove the bolts (A) and clips (B, C) securing the
© 2016-2025 Copyright www.hcrv.net
