Honda CR-V: Fuel Supply System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel Supply System
Component Location Index
-
FUEL RAIL
-
FUEL FEED LINE
-
FUEL TANK
-
FUEL TANK UNIT
-
FUEL PUMP
-
FUEL GAUGE SENDING UNIT
-
FUEL PRESSURE REGULATOR
-
FUEL FILTER
-
FUEL FILL CAP
-
FUEL FILL PIPE
-
FUEL LINE/QUICK-CONNECT FITTING
-
FUEL VAPOR LINE
-
FUEL LINE/QUICK-CONNECT FITTING
-
POWERTRAIN CONTROL MODULE (PCM)
-
PGM-FI MAIN RELAY 1
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
READ NEXT:
DTC Troubleshooting
DTC P0461: Fuel Level Sensor (Fuel Gauge
Sending Unit) Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshoo
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
f ill cap removed. The fu
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve
pressure from the system by disabling the fuel pump
and then disconnecting the fuel tube/quick connect
fitting in the engine compartment.
With the HDS
SEE MORE:
DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix
Control Motor Circuit
1. Start the engine.
2. Turn on the A/C, then set the temperature control
dial to Max Hot.
3. Turn the ignition switch OFF and then ON (II).
4. Do the self-diagnostic with the HVAC control unit.
5. Check for DTCs.
Is DTC 1 indicated?
Brake System
Brake System Inspection and Test
Inspect the brake system components listed. Repair or replace any parts that
are leaking or damaged.
Component Inspections
Brake System Test
Brake pedal sinks/fades when braking
1. Set the parking brake, and start the engine, then turn off the A/C switch.
Allow th
© 2016-2025 Copyright www.hcrv.net
