Honda CR-V: Doors
Honda CR-V (2006–2011) Service Manual / Body / Doors
Component Location Index-Front Door
- DOOR CENTER OUTER TRIM
- DOOR LINING BRACKETS
- DOOR OUTER MOLDING
- Replacement
- DOOR GLASS OUTER
WEATHERSTRIP
- Replacement
- HINGE
- DOOR CHECKER
- DOOR
- Position Adjustment
- SPEAKER
- DOOR WEATHERSTRIP
- Replacement
- PLASTIC COVER
- DOOR GLASS INNER WEATHERSTRIP
- DOOR PANEL
- POWER WINDOW SWITCH
- GLASS RUN CHANNEL
- GLASS
- FRONT LOWER CHANNEL
- CENTER LOWER CHANNEL
- REGULATOR
- RETAINER
- SPACER
- DOOR CYLINDER
- INNER HANDLE
- INNER HANDLE CAP
- LATCH CABLE
- LATCH
Component Location Index-Rear Door
- DOOR OUTER MOLDING
- DOOR GLASS OUTER WEATHERSTRIP
- DOOR QUARTER OUTER TRIM
- DOOR CENTER OUTER TRIM
- DOOR CHECKER
- HINGE
- DOOR
- DOOR PANEL
- POWER WINDOW SWITCH
- BRACKET
- DOOR WEATHERSTRIP
- PLASTIC COVER
- CENTER LOWER CHANNEL
- GLASS
- REGULATOR
- OUTER HANDLE
- LATCH PROTECTOR
- OUTER HANDLE PROTECTOR
- LATCH
- LATCH CABLE
- STRIKER
- INNER HANDLE CABLE
- INNER HANDLE CAP
- INNER HANDLE
READ NEXT:
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
Mirrors
Component Location Index
POWER MIRROR ACTUATOR
Replacement
POWER MIRROR
Replacement
MIRROR HOLDER
Replacement
MOUNT
REARVIEW MIRROR
Replacement
Power Mirror Replac
SEE MORE:
Transfer Assembly Inspection/Disassembly/Reassembly
Inspection
1. Set the dial indicator (A) on the companion flange
(B).
2. Measure the transfer gear backlash.
Standard: 0.06-0.16 mm (0.02-0.06 in.)
3. Secure the transfer housing (A) in a bench vise (B)
with soft jaws. To prevent damage to the transfer
housing, always use soft jaws or equivalent
m
DTC Troubleshooting
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed
© 2016-2026 Copyright www.hcrv.net
