Honda CR-V: Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 VTC Actuator, Exhaust Camshaft Sprocket Replacement

Removal 1. Remove the cam chain. 2. Hold the camshaft with an open-end wrench, then loosen the variable valve timing control (VTC) actuator mounting bolt and exhaust camshaft sprocket mounting bolt. 3. If the VTC actuator will be reused, do these steps. Remove the intake camshaft, and seal the

 Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC), System

The vehicle stability assist (VSA) system helps to stabilize the vehicle during cornering if the vehicle turns more or less than desired. It also assists you in maintaining traction while accelerating on loose or slippery road surfaces. It does this by regulating the engine’s output

© 2016-2025 Copyright www.hcrv.net