Honda CR-V: Bumpers
Honda CR-V (2006–2011) Service Manual / Body / Bumpers
READ NEXT:
Front Bumper
Front Bumper Removal/Installation
NOTE:
Have an assistant help you when removing and
installing the front bumper.
Take care not to scratch the front bumper and body.
Put on gloves to protect your
Rear Bumper
Rear Bumper Removal/Installation
NOTE:
Have an assistant help you when removing and
installing the rear bumper.
Take care not to scratch the rear bumper and body.
Put on gloves to protect your ha
Hood
Hood Adjustment
1. Remove these items:
Front bulkhead cover
Front fender trim
Cowl cover
2. Slightly loosen each bolt (A).
3. Adjust the hood alignment in this sequence:
Adjust the hood right
SEE MORE:
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
DTC P2270/P2271: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Lean/Rich
DTC P2270: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Lean
DTC P2271: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Rich
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2
© 2016-2025 Copyright www.hcrv.net
