Honda CR-V: Service Station Procedures

READ NEXT:

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

 Check Fuel Cap Message

Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho

SEE MORE:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

 Mirrors

Component Location Index POWER MIRROR ACTUATOR Replacement POWER MIRROR Replacement MIRROR HOLDER Replacement MOUNT REARVIEW MIRROR Replacement Power Mirror Replacement Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda T

© 2016-2026 Copyright www.hcrv.net