Honda CR-V: Seats
Honda CR-V (2006–2011) Service Manual / Body / Seats
Component Location Index
- REAR SEAT
- Removal/Installation
- Armrest Removal/Installation
- Armrest Cover Replacement
- Right Rear Seat Cover Replacement
- Left Rear Seat Cover Replacement
- Right Seat-back Lock Control Cable Replacement
- FRONT SEAT
- Front Seat Active Head Restraint Inspection
- Removal/Installation
- Seat Frame Replacement
- Recline Cover Removal/Installation
- Seat-back Cover/Pad Replacement
- Seat Cushion Cover/Pad Replacement
- Center Table Replacement
- Armrest Removal/Installation
- Under Tray Replacement
READ NEXT:
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armres
SEE MORE:
Symptom Troubleshooting
SRS indicator does not come on
1. Connect the HDS to the DLC.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does
not communicate, troubleshoot the DLC circuit.
4. Check for PGM-FI, Body Electrical, and SRS DTCs
with the HDS.
Are
Stabilizer
Stabilizer Link Removal/Installation
1. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the front wheel.
3. Remove the flange nuts while holding the
respective joint pin (A) with a hex wrench (B), then
remove the stabilizer link (C).
4. Inst
© 2016-2026 Copyright www.hcrv.net
