Honda CR-V: Seat Belt System Components

Your seat belt system includes lap/ shoulder belts in all seating positions.

The front seat belts are also equipped with automatic seat belt tensioners.

This system uses the same sensors as the front airbags to monitor whether the front seat belts are latched or unlatched, and how much weight is on the front passenger’s seat.

The seat belt system

The seat belt system includes an indicator on the instrument panel and a beeper to remind you and your passengers to fasten your seat belts.

This system monitors the front seat belts. If you turn the ignition switch to the ON (II) position before your seat belt is fastened, the beeper will sound and the indicator will flash. If your seat belt is not fastened before the beeper stops, the indicator will stop flashing but remain on.

If a front passenger does not fasten their seat belt, the indicator will come on about 6 seconds after the ignition switch is turned to the ON (II) position.

If either the driver or a front passenger does not fasten their seat belt while driving, the beeper will sound and the indicator will flash again at regular intervals.

When no one is sitting in the front passenger’s seat, or a child or small adult is riding there, the indicator should not come on and the beeper should not sound.

If the indicator comes on or the beeper sounds when the driver’s seat belt is latched and there is no front seat passenger and no items on the front seat, something may be interfering with the monitoring system. Look for and remove:

Any items under the front passenger’s seat.

Any object(s) hanging on the seat or in the seat-back pocket.

Any object(s), such as a foldeddown back seat, that are touching the rear of the seat-back.

If no obstructions are found, have your vehicle checked by a dealer.

READ NEXT:

 Lap/Shoulder Belt

The lap/shoulder belt goes over your shoulder, across your chest, and across your hips. To fasten the belt, insert the latch plate into the buckle, then tug on the belt to make sure the buckl

 Automatic Seat Belt Tensioners

For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a fr

 Seat Belt Maintenance

For safety, you should check the condition of your seat belts regularly. Pull each belt out fully, and look for frays, cuts, burns, and wear. Check that the latches work smoothly and the belt

SEE MORE:

 Alternator Removal and Installation

Removal 1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped), then write down the XM radio presets. 2. Disconnect the negative cable from the battery first, then disconnect the positive cable. 3. Remove the drive belt. 4. Remove the drive belt aut

 Steering

Special Tools Piston Seal Ring Sizing Tool Bushing Base Piston Seal Ring Guide Cylinder End Seal Slide Locknut Wrench, 40 mm Ball Joint Remover, 28 mm Valve Seal Ring Sizing Tool Sleeve Seal Ring Guide Pulley Holder Sleeve Seal Ring Sizing Tool, 36 mm P/S Joint Adapter (pump) P/S Join

© 2016-2024 Copyright www.hcrv.net