Honda CR-V: Seats
Honda CR-V (2006–2011) Service Manual / Body / Seats
Component Location Index
- REAR SEAT
- Removal/Installation
- Armrest Removal/Installation
- Armrest Cover Replacement
- Right Rear Seat Cover Replacement
- Left Rear Seat Cover Replacement
- Right Seat-back Lock Control Cable Replacement
- FRONT SEAT
- Front Seat Active Head Restraint Inspection
- Removal/Installation
- Seat Frame Replacement
- Recline Cover Removal/Installation
- Seat-back Cover/Pad Replacement
- Seat Cushion Cover/Pad Replacement
- Center Table Replacement
- Armrest Removal/Installation
- Under Tray Replacement
READ NEXT:
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armres
SEE MORE:
Brake Pedal Position Switch Signal Circuit Troubleshooting
1. Turn the ignition switch ON (II).
2. Check the BRAKE SWITCH in the DATA LIST with
the HDS.
Does it indicate OFF?
YES-Go to step 3.
NO-Inspect the brake pedal position switch.
3. Press the brake pedal, and check the BRAKE
SWITCH in the DATA LIST with the HDS.
Does it change to ON? YES-The bra
DTC P0137: Secondary HO2S (Sensor 2)
Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at
3,000 rpm without load (in Park or neutral) until t
© 2016-2025 Copyright www.hcrv.net
