Honda CR-V: Service Station Procedures

READ NEXT:

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

 Check Fuel Cap Message

Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho

SEE MORE:

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KTC

 DTC 31-3x ("x" can be 0 thru 9 or A thru F): Short to Another Wire or Decreased Resistance in Driver's Side Airbag Inflator

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 SRS short canceller 070AZ-SAA0100 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check t

© 2016-2025 Copyright www.hcrv.net