Honda CR-V: Doors
Honda CR-V (2006–2011) Service Manual / Body / Doors
Component Location Index-Front Door
- DOOR CENTER OUTER TRIM
- DOOR LINING BRACKETS
- DOOR OUTER MOLDING
- Replacement
- DOOR GLASS OUTER
WEATHERSTRIP
- Replacement
- HINGE
- DOOR CHECKER
- DOOR
- Position Adjustment
- SPEAKER
- DOOR WEATHERSTRIP
- Replacement
- PLASTIC COVER
- DOOR GLASS INNER WEATHERSTRIP
- DOOR PANEL
- POWER WINDOW SWITCH
- GLASS RUN CHANNEL
- GLASS
- FRONT LOWER CHANNEL
- CENTER LOWER CHANNEL
- REGULATOR
- RETAINER
- SPACER
- DOOR CYLINDER
- INNER HANDLE
- INNER HANDLE CAP
- LATCH CABLE
- LATCH
Component Location Index-Rear Door
- DOOR OUTER MOLDING
- DOOR GLASS OUTER WEATHERSTRIP
- DOOR QUARTER OUTER TRIM
- DOOR CENTER OUTER TRIM
- DOOR CHECKER
- HINGE
- DOOR
- DOOR PANEL
- POWER WINDOW SWITCH
- BRACKET
- DOOR WEATHERSTRIP
- PLASTIC COVER
- CENTER LOWER CHANNEL
- GLASS
- REGULATOR
- OUTER HANDLE
- LATCH PROTECTOR
- OUTER HANDLE PROTECTOR
- LATCH
- LATCH CABLE
- STRIKER
- INNER HANDLE CABLE
- INNER HANDLE CAP
- INNER HANDLE
READ NEXT:
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
Mirrors
Component Location Index
POWER MIRROR ACTUATOR
Replacement
POWER MIRROR
Replacement
MIRROR HOLDER
Replacement
MOUNT
REARVIEW MIRROR
Replacement
Power Mirror Replac
SEE MORE:
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
Shift Lock Release
This allows you to move the shift
lever out of Park if the normal
method of pushing on the brake
pedal and pressing the release
button does not work.
1. Set the parking brake.
2. Remove the key from the ignition
switch.
3. Put a cloth on the edge of the shift
lock release slot cover.
© 2016-2025 Copyright www.hcrv.net
