Honda CR-V: Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4. Turn the steering wheel to the full lock position. 5. Check the PSP SWITCH in the DATA LIST with t

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi). 3. Check for a drop in pressure. 4. If the pressure drops, replace the cap. Radiator Test 1. W

© 2016-2026 Copyright www.hcrv.net