Honda CR-V: If the EngineWon’t Start

Diagnosing why the engine won’t start falls into two areas, depending on what you hear when you turn the ignition switch to the START (III) position:

You hear nothing, or almost nothing. The engine’s starter motor does not operate at all, or operates very slowly.

You can hear the starter motor operating normally, or the starter motor sounds like it is spinning faster than normal, but the engine does not start up and run.

READ NEXT:

 Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing a

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using

 Jump Starting

Although this seems like a simple procedure, you should take several precautions. A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Ke

SEE MORE:

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to the MIN level. Is it at MIN level? YES-Raise the volume level, and recheck the function. NO-Go to

 Fuel Pressure Relieving

Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and then disconnecting the fuel tube/quick connect fitting in the engine compartment. With the HDS 1. Make sure you have the anti-theft code for the audio system. 2. Remove the fuel fill cap, to re

© 2016-2025 Copyright www.hcrv.net