Honda CR-V: Fuel Supply System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel Supply System
Component Location Index
-
FUEL RAIL
-
FUEL FEED LINE
-
FUEL TANK
-
FUEL TANK UNIT
-
FUEL PUMP
-
FUEL GAUGE SENDING UNIT
-
FUEL PRESSURE REGULATOR
-
FUEL FILTER
-
FUEL FILL CAP
-
FUEL FILL PIPE
-
FUEL LINE/QUICK-CONNECT FITTING
-
FUEL VAPOR LINE
-
FUEL LINE/QUICK-CONNECT FITTING
-
POWERTRAIN CONTROL MODULE (PCM)
-
PGM-FI MAIN RELAY 1
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
READ NEXT:
DTC Troubleshooting
DTC P0461: Fuel Level Sensor (Fuel Gauge
Sending Unit) Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshoo
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
f ill cap removed. The fu
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve
pressure from the system by disabling the fuel pump
and then disconnecting the fuel tube/quick connect
fitting in the engine compartment.
With the HDS
SEE MORE:
Tire Inspection
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Cuts, splits, or cracks in the side
of the tire. Repla
DTC 86: F-CAN Communication
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Start the engine.
5. Wait at least 5 seconds.
6. Check for DTCs with the HDS.
Is DTC 86 indicated?
YES-Go to step 7.
NO-Intermittent failure, the system is OK at this time. Check for a loos
© 2016-2025 Copyright www.hcrv.net
