Honda CR-V manuals

Honda CR-V: Fuel and Emissions Systems

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems

Special Tools

Honda CR-V. Fuel and Emissions Systems

Honda CR-V. Fuel and Emissions Systems

  1. Fuel Sender Wrench

  2. Fuel Pressure Gauge Attachment Set

  3. Vacuum/Pressure Gauge, 0-4 in.Hg

  4. Pressure Gauge Adapter

  5. Oil Pressure Hose

  6. A/T Pressure Hose

  7. A/T Low Pressure Gauge W/Pane

  8. A/T Pressure Hose, 2,210 mm

  9. A/T Pressure Hose, Adapter

  10. Fuel Pressure Gauge

READ NEXT:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

 System Description

Electronic Control System The functions of the fuel and emission control systems are managed by the powertrain control module (PCM). Self-diagnosis The PCM detects a failure of a signal from a sensor

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehi

SEE MORE:

 Damper/Spring

Damper/Spring Removal and Installation Removal 1. Turn the ignition switch ON (II), then turn on the windshield wipers. Turn the ignition switch off when the wipers are near the A-pillars. 2. Raise the front of the vehicle, and support it with safety stands in the proper locations. 3. Remove th

 Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the power steering (P/S) fluid reservoir from the holder. 3. Remove the upper torque rod. 4. Remove the ground cable (A), then remove the side engine mount bracket (B). 5. Remove the side engine mount stiffener (A), th

© 2016-2025 Copyright www.hcrv.net