Honda CR-V: Fuel and Emissions Systems
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems
Special Tools
-
Fuel Sender Wrench
-
Fuel Pressure Gauge Attachment Set
-
Vacuum/Pressure Gauge, 0-4 in.Hg
-
Pressure Gauge Adapter
-
Oil Pressure Hose
-
A/T Pressure Hose
-
A/T Low Pressure Gauge W/Pane
-
A/T Pressure Hose, 2,210 mm
-
A/T Pressure Hose, Adapter
-
Fuel Pressure Gauge
READ NEXT:
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
How to Set Readiness Codes
Malfunction Indicator Lamp (MIL) Indication
(In relation to Readiness Codes)
The vehicle has certain "readiness codes" that are part
of the on-board diagnostics for the emissions systems.
If the vehi
SEE MORE:
Rear Window Wiper and Washer
1. OFF
When you turn the wiper switch to
the ‘‘OFF’’ position, the wiper will
return to its parked position.
2. Rotate the switch clockwise to
turn the rear window wiper ON.
The wiper operates every 7
seconds after completing two
sweeps.
3. Hold past ON to activate the rea
Cylinder Head Removal
NOTE:
Use fender covers to avoid damaging painted
surfaces.
To avoid damage, unplug the wiring connectors
carefully while holding the connector portion.
To avoid damaging the cylinder head, wait until the
engine coolant temperature drops below 100 ºF
(38 ºC) before loosening the cylinder h
© 2016-2025 Copyright www.hcrv.net
