Honda CR-V: Differential Mount Replacement

Exploded View

Honda CR-V. Rear Differential

Differential Installation

1. Install rear differential mount assembly A to the rear differential assembly (B).

Honda CR-V. Rear Differential

2. Jack up the rear differential.

3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential.

Honda CR-V. Rear Differential

4. Lift the rear differential up into position, then push on both driveshafts to lock the set rings into place.

Connect the breather tube (B).

5. Align the tab (A) of the rubber mount (B) with the hole (C) of the plates (D), then install the plates and torque the rear differential mount assembly mounting bolts (E).

NOTE: The rubber heat insulator (F) is installed only in the right side.

Honda CR-V. Rear Differential

6. Install the breather tubes (G) to the clips (H).

7. Install the right and left rear differential mount brackets B (A), then torque the bolts (B).

Honda CR-V. Rear Differential

8. Install the breather tube (C) to the clip (D).

9. Install the No.2 propeller shaft (A) onto the rear differential (B) by aligning the reference marks (C) made during removal. Make sure you use new mounting bolts (D).

Honda CR-V. Rear Differential

10. Fill the rear differential with the differential fluid to the proper level.

READ NEXT:

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

SEE MORE:

 Folding the Rear Seats Down

Each rear seat-back can be folded down separately to give more cargo room. With either of the outer seatbacks folded-down, you can still carry a passenger in the rear seat. With the center seat-back foldeddown, either outer seating position can be used. You can also fold up the left or

 To Load a Disc

The in-dash disc player is behind the navigation screen. To use the disc player, press the OPEN button beside the screen. The screen folds back, and the disc slot appears. Insert a disc about halfway into the disc slot. The drive will pull the disc in the rest of the way and beg

© 2016-2025 Copyright www.hcrv.net