Honda CR-V: Accessory Power Sockets
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets
Your vehicle has two or three accessory power sockets depending on the model.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
READ NEXT:
Console Compartment
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
Coat Hook
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
Seat Under Tray
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
The Starter Operates Normally
In this case, the starter motor’s
speed sounds normal, or even faster
than normal, when you turn the
ignition switch to the START (III)
position, but the engine does not run.
Are you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in t
Seat Belt System Components
Your seat belt system includes lap/
shoulder belts in all seating positions.
The front seat belts are also
equipped with automatic seat belt
tensioners.
This system uses the same sensors
as the front airbags to monitor
whether the front seat belts are
latched or unlatched, and how much
© 2016-2026 Copyright www.hcrv.net
