Honda CR-V manuals

Honda CR-V: Fuel and Emissions Systems

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems

Special Tools

Honda CR-V. Fuel and Emissions Systems

Honda CR-V. Fuel and Emissions Systems

  1. Fuel Sender Wrench

  2. Fuel Pressure Gauge Attachment Set

  3. Vacuum/Pressure Gauge, 0-4 in.Hg

  4. Pressure Gauge Adapter

  5. Oil Pressure Hose

  6. A/T Pressure Hose

  7. A/T Low Pressure Gauge W/Pane

  8. A/T Pressure Hose, 2,210 mm

  9. A/T Pressure Hose, Adapter

  10. Fuel Pressure Gauge

READ NEXT:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

 System Description

Electronic Control System The functions of the fuel and emission control systems are managed by the powertrain control module (PCM). Self-diagnosis The PCM detects a failure of a signal from a sensor

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehi

SEE MORE:

 To Play a Disc

To load or play discs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the disc changer with the same controls used for the radio. To select the disc changer, press the CD button (CD/AUX button on models with satellite radio), the disc and track number

 DTC Troubleshooting

DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Start the engine. 2. Turn on the A/C, then set the temperature control dial to Max Hot. 3. Turn the ignition switch OFF and then ON (II). 4. Do the self-diagnostic with the HVAC control unit. 5. Check for DTCs. Is DTC 1 indicated?

© 2016-2025 Copyright www.hcrv.net