Honda CR-V: Fuel and Emissions Systems
Special Tools


-
Fuel Sender Wrench
-
Fuel Pressure Gauge Attachment Set
-
Vacuum/Pressure Gauge, 0-4 in.Hg
-
Pressure Gauge Adapter
-
Oil Pressure Hose
-
A/T Pressure Hose
-
A/T Low Pressure Gauge W/Pane
-
A/T Pressure Hose, 2,210 mm
-
A/T Pressure Hose, Adapter
-
Fuel Pressure Gauge
READ NEXT:
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
Malfunction Indicator Lamp (MIL) Indication
(In relation to Readiness Codes)
The vehicle has certain "readiness codes" that are part
of the on-board diagnostics for the emissions systems.
If the vehi
SEE MORE:
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07 AAE-SEPA 101
CAUTION
Frequent inhalation of brake pad dust, regardless of
material composition, could be hazardous to your
health.
Avoid breathing dust particles.
Never use an air hose or brush to
Under-cowl Panel Replacement
NOTE: Take care not to scratch the body.
1. Remove these items:
Windshield wiper arms
Front fender trim, both sides
Cowl covers
2. Remove the bolts and nuts, disconnect the
connector (A) and remove the grommet (B), then
remove the under-cowl panel (C).
3. Install
© 2016-2025 Copyright www.hcrv.net
