Honda CR-V manuals

Honda CR-V: Interior Trim

Honda CR-V (2006–2011) Service Manual / Body / Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

 Fuel Fill Door

Fuel Fill Door Adjustment 1. Remove the nut (A), then remove the open spring (B). 2. Slightly loosen the hinge mounting bolts (A). 3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps. 4. Tighten the hinge mounting bolts. 5. C

© 2016-2025 Copyright www.hcrv.net