Honda CR-V: Fuel and Emissions Systems
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems
Special Tools
-
Fuel Sender Wrench
-
Fuel Pressure Gauge Attachment Set
-
Vacuum/Pressure Gauge, 0-4 in.Hg
-
Pressure Gauge Adapter
-
Oil Pressure Hose
-
A/T Pressure Hose
-
A/T Low Pressure Gauge W/Pane
-
A/T Pressure Hose, 2,210 mm
-
A/T Pressure Hose, Adapter
-
Fuel Pressure Gauge
READ NEXT:
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
How to Set Readiness Codes
Malfunction Indicator Lamp (MIL) Indication
(In relation to Readiness Codes)
The vehicle has certain "readiness codes" that are part
of the on-board diagnostics for the emissions systems.
If the vehi
SEE MORE:
Seat Heaters
If equipped
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
The ignition switch must be in the
ON (II) position to use the heaters.
Push the top of the switch, HI, to
rapidly heat
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
ignition switch to the ON (II)
position to operate the moonroof.
To tilt up the moonroof, push
© 2016-2025 Copyright www.hcrv.net
