Honda CR-V: Engine Lubrication

Special Tools

Honda CR-V. Engine Lubrication

  1. Oil Filter Wrench

Component Location Index

Honda CR-V. Engine Lubrication

Symptom Troubleshooting Index

Honda CR-V. Engine Lubrication

Low Oil Pressure Indicator Circuit Diagram

Honda CR-V. Engine Lubrication

READ NEXT:

 Low Oil Pressure Indicator Circuit Troubleshooting (Open)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2). 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the powertrain

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain ten

 Intake Manifold and Exhaust System

Intake Manifold Removal and Installation Exploded View Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disc

SEE MORE:

 DTC P0705: Short in Transmission Range Switch Circuit (Multiple Shift-Position Input)

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HDS. 2. Start the

 Adjust the Front Seats

Adjust the driver’s seat as far to the rear as possible while allowing you to maintain full control of the vehicle. Have a front passenger adjust their seat as far to the rear as possible. If you sit too close to the steering wheel or dashboard, you can be seriously injured by an i

© 2016-2025 Copyright www.hcrv.net