Honda CR-V manuals

Honda CR-V: Fuel and Emissions Systems

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems

Special Tools

Honda CR-V. Fuel and Emissions Systems

Honda CR-V. Fuel and Emissions Systems

  1. Fuel Sender Wrench

  2. Fuel Pressure Gauge Attachment Set

  3. Vacuum/Pressure Gauge, 0-4 in.Hg

  4. Pressure Gauge Adapter

  5. Oil Pressure Hose

  6. A/T Pressure Hose

  7. A/T Low Pressure Gauge W/Pane

  8. A/T Pressure Hose, 2,210 mm

  9. A/T Pressure Hose, Adapter

  10. Fuel Pressure Gauge

READ NEXT:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

 System Description

Electronic Control System The functions of the fuel and emission control systems are managed by the powertrain control module (PCM). Self-diagnosis The PCM detects a failure of a signal from a sensor

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehi

SEE MORE:

 Resetting the Engine Oil Life Display

Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition switch to the ON (II) position. If maintenance service is done by someone other than your dealer,

 Transfer Assembly Inspection/Removal/Installation

Transfer Assembly Inspection 1. Shift the transmission into the N position. 2. Raise the vehicle on a lift, and make sure it is supported securely. 3. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C). 4. Separate the propeller shaft from the transfer

© 2016-2025 Copyright www.hcrv.net