Honda CR-V: Interior Trim
Honda CR-V (2006–2011) Service Manual / Body / Interior Trim
Component Location Index
- TAILGATE SIDE TRIM
- Removal/Installation
- TAILGATE UPPER TRIM
- Removal/Installation
- QUARTER PILLAR GLASS TRIM
- Removal/Installation
- REAR DOOR OPENING SEAL
- Removal/Installation
- B-PILLAR UPPER TRIM
- Removal/Installation
- FRONT DOOR OPENING SEAL
- Removal/Installation
- SUNVISOR
- Removal/installation
- A-PILLAR TRIM
- Removal/Installation
- GRAB HANDLE
- Removal/Installation
- HEADLINER
- Removal/Installation
- FRONT SIDE OUTER TRIM
- Removal/Installation
- FRONT DOOR SILL TRIM
- Removal/Installation
- CARPET
- Replacement
- REAR SIDE OUTER TRIM
- Removal/Installation
- B-PILLAR LOWER TRIM
- Removal/Installation
- REAR DOOR SILL TRIM
- Removal/Installation
- DUAL DECK CARGO SHELF
- Removal/ Installation
- CARGO AREA FLOOR
- Removal/Installation
- TAILGATE LOWER TRIM PANEL
- Removal/Installation
- CARGO AREA SIDE TRIM PANEL
- Removal/Installation
READ NEXT:
Trim Removal/Installation
Trim Removal/Installation-Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are loc
Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Use the appropr
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before
doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Use the a
SEE MORE:
Immobilizer System
Component Location Index
IMMOBILIZER INDICATOR
IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
UNDER-DASH
FUSE/RELAY BOX
IMOES UNIT
(Built into the MICU)
PCM
IGNITION KEY
TRANSPONDER
(Combined with the
keyless transmitter)
System Description
The vehicle is equipped with an im
ATF Temperature Sensor
ATF Temperature Sensor Test/Replacement
1. Raise the vehicle on a lift, or apply the parking
brake, block the rear wheels, and raise the front of
the vehicle. Make sure it is securely supported.
2. Remove the splash shield.
3. Disconnect the shift solenoid harness connector.
4. Measure the ATF te
© 2016-2026 Copyright www.hcrv.net
