Honda CR-V: Doors
Honda CR-V (2006–2011) Service Manual / Body / Doors
Component Location Index-Front Door
- DOOR CENTER OUTER TRIM
- DOOR LINING BRACKETS
- DOOR OUTER MOLDING
- Replacement
- DOOR GLASS OUTER
WEATHERSTRIP
- Replacement
- HINGE
- DOOR CHECKER
- DOOR
- Position Adjustment
- SPEAKER
- DOOR WEATHERSTRIP
- Replacement
- PLASTIC COVER
- DOOR GLASS INNER WEATHERSTRIP
- DOOR PANEL
- POWER WINDOW SWITCH
- GLASS RUN CHANNEL
- GLASS
- FRONT LOWER CHANNEL
- CENTER LOWER CHANNEL
- REGULATOR
- RETAINER
- SPACER
- DOOR CYLINDER
- INNER HANDLE
- INNER HANDLE CAP
- LATCH CABLE
- LATCH
Component Location Index-Rear Door
- DOOR OUTER MOLDING
- DOOR GLASS OUTER WEATHERSTRIP
- DOOR QUARTER OUTER TRIM
- DOOR CENTER OUTER TRIM
- DOOR CHECKER
- HINGE
- DOOR
- DOOR PANEL
- POWER WINDOW SWITCH
- BRACKET
- DOOR WEATHERSTRIP
- PLASTIC COVER
- CENTER LOWER CHANNEL
- GLASS
- REGULATOR
- OUTER HANDLE
- LATCH PROTECTOR
- OUTER HANDLE PROTECTOR
- LATCH
- LATCH CABLE
- STRIKER
- INNER HANDLE CABLE
- INNER HANDLE CAP
- INNER HANDLE
READ NEXT:
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
Mirrors
Component Location Index
POWER MIRROR ACTUATOR
Replacement
POWER MIRROR
Replacement
MIRROR HOLDER
Replacement
MOUNT
REARVIEW MIRROR
Replacement
Power Mirror Replac
SEE MORE:
DTC 33-9x ("x" can be 0 thru 9 or A thru F):
Short to Ground in Left Side Curtain Airbag
Inflator
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead L 070AZ-SNAA300
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for a
A/C Signal Circuit Troubleshooting
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check the A/C system.
Does the A/C system operate? YES-The air conditioning system circuit is OK.
NO-Go t
© 2016-2026 Copyright www.hcrv.net
