Honda CR-V: Interior Trim
Honda CR-V (2006–2011) Service Manual / Body / Interior Trim
Component Location Index
- TAILGATE SIDE TRIM
- Removal/Installation
- TAILGATE UPPER TRIM
- Removal/Installation
- QUARTER PILLAR GLASS TRIM
- Removal/Installation
- REAR DOOR OPENING SEAL
- Removal/Installation
- B-PILLAR UPPER TRIM
- Removal/Installation
- FRONT DOOR OPENING SEAL
- Removal/Installation
- SUNVISOR
- Removal/installation
- A-PILLAR TRIM
- Removal/Installation
- GRAB HANDLE
- Removal/Installation
- HEADLINER
- Removal/Installation
- FRONT SIDE OUTER TRIM
- Removal/Installation
- FRONT DOOR SILL TRIM
- Removal/Installation
- CARPET
- Replacement
- REAR SIDE OUTER TRIM
- Removal/Installation
- B-PILLAR LOWER TRIM
- Removal/Installation
- REAR DOOR SILL TRIM
- Removal/Installation
- DUAL DECK CARGO SHELF
- Removal/ Installation
- CARGO AREA FLOOR
- Removal/Installation
- TAILGATE LOWER TRIM PANEL
- Removal/Installation
- CARGO AREA SIDE TRIM PANEL
- Removal/Installation
READ NEXT:
Trim Removal/Installation
Trim Removal/Installation-Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are loc
Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Use the appropr
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before
doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Use the a
SEE MORE:
Component Replacement/Inspection After
Deployment
NOTE:
Before doing any SRS repairs, use the HDS SRS
menu method to check for DTCs; refer to the DTC
Troubleshooting Index for the less obvious deployed
parts (seat belt tensioners, front impact sensors, side
airbag sensors, etc.)
Do not replace the ODS unit unless it is physically
damaged or
XM radio display is blank and no station
information is displayed
1. Disconnect audio disc changer 13P connector.
2. Turn the ignition switch to ACC (I).
3. Operate the XM radio, and check the display.
Is XM information displayed? YES-Replace the audio disc changer.
NO-Go to step 4.
4. Check the No. 34 (7.5 A) fuse in the under-dash
fuse/relay box and the No.
© 2016-2025 Copyright www.hcrv.net
