Honda CR-V: Engine Lubrication
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Lubrication
Special Tools
-
Oil Filter Wrench
Component Location Index
-
OIL PAN
-
WASHER
-
DRAIN BOLT
-
OIL PUMP
-
OIL PUMP CHAIN GUIDE
-
OIL PUMP CHAIN TENSIONER
-
OIL CONTROL ORIFICE
-
OIL FILTER
-
OIL FILTER FEED PIPE
-
OIL FILTER BASE
-
ENGINE OIL GALLERY CAP
-
OIL PRESSURE SWITCH
Symptom Troubleshooting Index
Low Oil Pressure Indicator Circuit Diagram
READ NEXT:
Low Oil Pressure Indicator Circuit
Troubleshooting (Open)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle
and the powertrain
Oil Pump Overhaul
Exploded View
Oil Pump Removal
1. Turn the crankshaft pulley so its top dead center
(TDC) mark (A) lines up with the pointer (B).
2. Remove the oil pan.
3. Remove and discard the oil pump chain ten
Intake Manifold and Exhaust System
Intake Manifold Removal and Installation
Exploded View
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disc
SEE MORE:
EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator hose (A), heater hose
(B), and water bypass hose (C).
5. Remove the air cleaner housing brackets.
6
If the Engine Overheats
The reading of the vehicle’s
temperature gauge should stay in
the midrange. If it climbs to the red
mark, you should determine the
reason (hot day, driving up a steep
hill, etc.).
If the vehicle overheats, you should
take immediate action. The only
indication may be the temperature
© 2016-2025 Copyright www.hcrv.net
