Honda CR-V: Seats
Honda CR-V (2006–2011) Service Manual / Body / Seats
Component Location Index
- REAR SEAT
- Removal/Installation
- Armrest Removal/Installation
- Armrest Cover Replacement
- Right Rear Seat Cover Replacement
- Left Rear Seat Cover Replacement
- Right Seat-back Lock Control Cable Replacement
- FRONT SEAT
- Front Seat Active Head Restraint Inspection
- Removal/Installation
- Seat Frame Replacement
- Recline Cover Removal/Installation
- Seat-back Cover/Pad Replacement
- Seat Cushion Cover/Pad Replacement
- Center Table Replacement
- Armrest Removal/Installation
- Under Tray Replacement
READ NEXT:
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armres
SEE MORE:
DTC P2135: TP Sensor A/B Voltage Incorrect
Correlation
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers if the throttle valve
is activated.
NOTE: Before you troubleshoot, record all freeze data and any o
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Check TP SENSOR A in the DATA LIST with the
HDS.
Is there about 0.3 V or less?
YES-Go to ste
© 2016-2026 Copyright www.hcrv.net
