Honda CR-V manuals

Honda CR-V: Fuel and Emissions Systems

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems

Special Tools

Honda CR-V. Fuel and Emissions Systems

Honda CR-V. Fuel and Emissions Systems

  1. Fuel Sender Wrench

  2. Fuel Pressure Gauge Attachment Set

  3. Vacuum/Pressure Gauge, 0-4 in.Hg

  4. Pressure Gauge Adapter

  5. Oil Pressure Hose

  6. A/T Pressure Hose

  7. A/T Low Pressure Gauge W/Pane

  8. A/T Pressure Hose, 2,210 mm

  9. A/T Pressure Hose, Adapter

  10. Fuel Pressure Gauge

READ NEXT:

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

 System Description

Electronic Control System The functions of the fuel and emission control systems are managed by the powertrain control module (PCM). Self-diagnosis The PCM detects a failure of a signal from a sensor

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehi

SEE MORE:

 Front Driveshaft Installation

1. Apply grease to the contact area (A) of the outboard joint and front wheel bearing. NOTE: Failure to apply grease may cause excessive noise and vibration. 2. Install a new set ring (A) onto the set ring groove (B) of the driveshaft (left driveshaft). 3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease

 Important Handling Information

Your CR-V has higher ground clearance than a passenger vehicle designed for use only on pavement. Higher ground clearance has many advantages for off-highway driving. It allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate prob

© 2016-2026 Copyright www.hcrv.net