Honda CR-V: Bumpers

READ NEXT:

 Front Bumper

Front Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the front bumper. Take care not to scratch the front bumper and body. Put on gloves to protect your

 Rear Bumper

Rear Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the rear bumper. Take care not to scratch the rear bumper and body. Put on gloves to protect your ha

 Hood

Hood Adjustment 1. Remove these items: Front bulkhead cover Front fender trim Cowl cover 2. Slightly loosen each bolt (A). 3. Adjust the hood alignment in this sequence: Adjust the hood right

SEE MORE:

 Moonroof

If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the ignition switch to the ON (II) position to operate the moonroof. To tilt up the moonroof, push

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the HDS. 4. Turn the ignition switch OFF, then turn it ON (II) again. 5. Check for DTCs with the HDS.

© 2016-2025 Copyright www.hcrv.net