Honda CR-V: Engine Lubrication
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Lubrication
Special Tools
-
Oil Filter Wrench
Component Location Index
-
OIL PAN
-
WASHER
-
DRAIN BOLT
-
OIL PUMP
-
OIL PUMP CHAIN GUIDE
-
OIL PUMP CHAIN TENSIONER
-
OIL CONTROL ORIFICE
-
OIL FILTER
-
OIL FILTER FEED PIPE
-
OIL FILTER BASE
-
ENGINE OIL GALLERY CAP
-
OIL PRESSURE SWITCH
Symptom Troubleshooting Index
Low Oil Pressure Indicator Circuit Diagram
READ NEXT:
Low Oil Pressure Indicator Circuit
Troubleshooting (Open)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle
and the powertrain
Oil Pump Overhaul
Exploded View
Oil Pump Removal
1. Turn the crankshaft pulley so its top dead center
(TDC) mark (A) lines up with the pointer (B).
2. Remove the oil pan.
3. Remove and discard the oil pump chain ten
Intake Manifold and Exhaust System
Intake Manifold Removal and Installation
Exploded View
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disc
SEE MORE:
Using the Heater
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
1. Select
.
When you select
, the system
automatically switches to fresh air
mode. If you switch the mode
from
or
, the system
als
DTC P0731: Problem in 1st Clutch and 1st
Clutch Hydraulic Circuit
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
© 2016-2025 Copyright www.hcrv.net
