Honda CR-V: Interior Trim
Honda CR-V (2006–2011) Service Manual / Body / Interior Trim
Component Location Index
- TAILGATE SIDE TRIM
- Removal/Installation
- TAILGATE UPPER TRIM
- Removal/Installation
- QUARTER PILLAR GLASS TRIM
- Removal/Installation
- REAR DOOR OPENING SEAL
- Removal/Installation
- B-PILLAR UPPER TRIM
- Removal/Installation
- FRONT DOOR OPENING SEAL
- Removal/Installation
- SUNVISOR
- Removal/installation
- A-PILLAR TRIM
- Removal/Installation
- GRAB HANDLE
- Removal/Installation
- HEADLINER
- Removal/Installation
- FRONT SIDE OUTER TRIM
- Removal/Installation
- FRONT DOOR SILL TRIM
- Removal/Installation
- CARPET
- Replacement
- REAR SIDE OUTER TRIM
- Removal/Installation
- B-PILLAR LOWER TRIM
- Removal/Installation
- REAR DOOR SILL TRIM
- Removal/Installation
- DUAL DECK CARGO SHELF
- Removal/ Installation
- CARGO AREA FLOOR
- Removal/Installation
- TAILGATE LOWER TRIM PANEL
- Removal/Installation
- CARGO AREA SIDE TRIM PANEL
- Removal/Installation
READ NEXT:
Trim Removal/Installation
Trim Removal/Installation-Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are loc
Sunvisor Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Use the appropr
Headliner Removal/Installation
SRS components are located in this area. Review the SRS component locations
and the precautions and procedures before
doing repairs or service.
NOTE:
Put on gloves to protect your hands.
Use the a
SEE MORE:
DTC 22-3x ("x" can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in Front Passenger's Seat Belt
Tensioner
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead K 070AZ-SNAA200
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for ab
DTC 86: F-CAN Communication
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Start the engine.
5. Wait at least 5 seconds.
6. Check for DTCs with the HDS.
Is DTC 86 indicated?
YES-Go to step 7.
NO-Intermittent failure, the system is OK at this time. Check for a loos
© 2016-2025 Copyright www.hcrv.net
