Honda CR-V: Bumpers

READ NEXT:

 Front Bumper

Front Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the front bumper. Take care not to scratch the front bumper and body. Put on gloves to protect your

 Rear Bumper

Rear Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the rear bumper. Take care not to scratch the rear bumper and body. Put on gloves to protect your ha

 Hood

Hood Adjustment 1. Remove these items: Front bulkhead cover Front fender trim Cowl cover 2. Slightly loosen each bolt (A). 3. Adjust the hood alignment in this sequence: Adjust the hood right

SEE MORE:

 Rear Brake

Rear Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07AAE-SEPA101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to -your health. Avoid breathing dust particles. Never use an air hose or brush to

 DTC 83-26: No Signal From the Front Passenger's Weight Sensor (rear outer side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 83-26 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From INSPECTION m

© 2016-2026 Copyright www.hcrv.net