Honda CR-V: EVAP System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / EVAP System
Component Location Index
- EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
- Replacement
- POWERTRAIN CONTROL MODULE (PCM)
- General Troubleshooting Information
- Replacement
- FUEL TANK VAPOR CONTROL VALVE
- FUEL FILL CAP
- FUEL TANK PRESSURE
(FTP) SENSOR
- Replacement
- EVAPORATIVE EMISSION
(EVAP) CANISTER
- Replacement
- EVAPORATIVE EMISSION (EVAP)
CANISTER VENT SHUT VALVE
- Replacement
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
SEE MORE:
EVAP Canister Replacement
1. Lift the vehicle, and support it with jackstands.
2. Remove the cover (A).
3. Remove the EVAP canister baffle cover (A).
4. Disconnect the hoses (A) and the fuel subharness
6P connector (B).
5. Remove the bolts (C) and the EVAP canister bracket
(D).
6. Remove the EVAP canister (A) from the E
Starting System
Component Location Index
STARTER CUT RELAY
UNDER-DASH
FUSE/RELAY BOX
STARTER
Starter Circuit Troubleshooting
Performance Test
Removal and Installation
Overhaul
TRANSMISSION RANGE SWITCH
Test
Replacement
Symptom Troubleshooting
Index
Engine
© 2016-2025 Copyright www.hcrv.net
